3m Espe Filtek Z350 XT Universal Restorative Composite Compule Refills

• Composite Type: Universal
• Cure Type: Light Cure
• Delivery System: Capsule
• Material Structure: Nanocomposite
• Opacity: Body
• Shades: A1B, A2B, A3B, A3.5B, B1B, B2B
• Composition: Bis-GMA, UDMA, TEGDMA, and bis-EMA(6) resins. To moderate the shrinkage, PEGDMA has been substituted for a portion of the TEGDMA resin in 3M™ Filtek™ Z350 Restorative.
• Units per Inner Pack: 20 per Pack
• Net Weight: 0.2g

• 1 x Box of 20 Capsule (0.2g each)

Isolation and Preparation:

• Isolate the tooth to be restored to prevent contamination.
• Clean the tooth surface thoroughly.

Etching:

• Apply 37% phosphoric acid etchant to the enamel and dentin surfaces.
• Leave it for 15-30 seconds on enamel and 10-15 seconds on dentin.
• Rinse thoroughly with water and air dry. Ensure the tooth is not over-dried.

Bonding:

• Apply 3M™ Scotchbond™ Universal Plus Adhesive to the etched surfaces.
• Scrub the adhesive for 20 seconds, air thin to evaporate the solvent, and light-cure for 10 seconds.

Application:

• Load the compule into the composite dispensing gun.
• Place the tip of the compule directly on the prepared cavity floor.
• Inject the composite in increments, each not exceeding 2mm.

Curing:

• Light-cure each increment for 20 seconds using a curing light.
• Ensure the curing light is held close to the composite surface without touching it.

Shaping and Finishing:

• Shape the restoration using appropriate dental instruments.
• Use fine and extra-fine diamond burs for initial contouring.
• Polish the restoration with composite polishers for a high-gloss finish.

Final Inspection:

• Check the restoration for any occlusal high spots.
• Adjust if necessary, ensuring the patient’s bite is comfortable.

Post-Operative Care:

• Instruct the patient on post-operative care and advise them to avoid hard foods for the first 24 hours.

• Warranty is not applicable for this product